How To Install Metal Starter Strip For Vinyl Siding

In order for the siding to be installed properly in a level fashion the starter strip at the bottom of the wall must be level.

How to install metal starter strip for vinyl siding.

This video shows how to install a starter strip for vinyl and polymer siding installation. Locate the lowest possible corner that has sheathing. Then nail them to the surface you re working on leaving 16 inches 41 cm between each strip. Staret strip secures the first course of siding to the home.

This is where the new siding will begin. How to install a vinyl siding starter strip. It protects the sheathing from rain snow and pests. Vinyl siding starter strips.

From that point measure up 1 4 6 4mm less than the width of the starter strip and partially drive a nail at one corner. To install the furring strips start by cutting them to size so they run from one end of the surface to the other. Hold a tape measure against the exterior wall and travel around the house to locate. Putting up furring strips will help even out the surface you re working on so the metal siding doesn t look wavy.

Determine the lowest point of the wall that will be sided. Then nail a 3 1 2 in. Use the wider starter strip the bottom of the starter strip the part the bottom panel hooks on to should be at least 1 in. Below the top of the foundation but the lower the vinyl siding is installed the better.

When you ve determined the best height for the metal starter strip mark this position on the walls and snap a reference chalkline around the entire house.