Drip edge flashing can be used for new construction and reroofing projects.
How to install vinyl drip edge for vinyl gutters.
While the vertical leg should be placed 1 4 1 2 away from the fascia.
Nail high up on the drip edge so that the shingles will cover the nails.
Since soffit runs perpendicular to the wall you will be cutting many short pieces depending on the width of your overhang.
The end with the flange or flare should point down and away from the roof.
Then secure gutter hangers along your house and fit the gutter sections into them.
To install vinyl gutters you ll need to start by installing downspout outlets on the edges of your house so water can drain properly from the gutters.
Slide one end into the j channel and nail the far side of the soffit to the wood fascia board using one nail to keep the soffit in place until you install the vinyl fascia.
Make sure the corner is tight and that the bottom edge is tight to the fascia before nailing off the drip edge.
Next attach drainpipes to carry water from the downspout outlets to the ground and away from your house.
Use along gutter line of the roof edge.
Place a nail at one end then the other.
Apply a continuous bead of cement along the top of the drip edge then press down on the shingle.
Make sure to support the long end of the cut if you let it fall after cutting it will bend down and kink the drip edge.
Use roofing nails to secure the drip edge.
Overhanging drip edge gives maximum protection from roof run off.
Nailing edge with 1 in.
You may need to nail through the starter strip into the drip edge.
The roof leg should extend a minimum of 2 back onto the roof sheathing.
To install a drip edge on a newly constructed roof or on a re roofing job attach the drip edge along the roof s eaves first.
Made from high quality vinyl construction.
Install by nailing under shingles.
Drip edge is used to direct rainwater off of the roof and into your gutter system.
If necessary secure the ends of the drip edge with short roofing nails.
Place the drip edge down aligning it so water will drip into the gutters.
Most overhangs are 6 or 1.
Secure the drip edge with roofing cement.
Just be sure they re positioned high up under the shingles.