How To Install Vinyl Siding Last Row

How to install the top row of vinyl siding step 1.

How to install vinyl siding last row.

Install the tops first then the sides and then the bottoms of the window surrounds. Then notch the next piece to fit. But if the result is not a whole number you will need to cut the final piece of siding lengthwise in order to fill in. Along the tops install j channel trim with horizontal siding and base trim with vertical siding.

The bottom of the starter strip the part the bottom panel hooks on to should be at least 1 in. Use the wider starter strip. You must leave the bottom. Measure and cut panel in the same manner detailed in step 14 but cut lower portion instead of top.

Push the top of the vinyl siding with the tabs into the utility trim just enough to hold the edge and push the bottom against the second to last piece of siding. Use this template. If you have to cut the last row of siding you ll. Finishing top row of siding under eaves.

How do i put up a top piece of vinyl siding. With the insulation backing in place install siding to within one row of the bottom of the window. To stiffen the trimmed section slide a length of utility trim. Mark the length of vinyl where the cut needs to be made to achieve the correct fit.

Once it is in place test by sliding the last piece back and forth slightly. Using a piece of scrap siding as a template measure the width of the second to last row marking it with your pencil. Vinyl siding installation is designed to hang loosely on the sheathing so that it can expand and contract with temperature changes. Divide the length of each wall by 8 inches the width of a piece of siding.

Be sure the top and bottom click into place. Gap at all ends. Cut the trim so it is two channel widths longer than the opening s width. Measure and cut panel to fit.

The siding slides behind vinyl siding trim pieces that hide the gap and the cut end. Drop siding panel into j channel around top of window and install. Install j channels at doors and windows and under roof eaves and rakes. Install siding as normal until you reach the second row from the top.

To prevent the relatively thin panels from buckling observe these fitting and nailing rules. Score the vinyl siding at the mark and break off the excess top by. Measure the gap remaining at the top of the wall. Push up gently until you hear a click.

Be sure to check both sides for proper fit.