How To Operate An A And E Awning

Circuit board wiring section 3 1 4 8.

How to operate an a and e awning.

Awning works in opposite direction 1. Gently pull on the chain and hook the the s hook on the chain to the hole in your awning s foot. From the ground hook the s hook on the spring over the rod and hold it into place on the rod by pulling on the chain as you raise it and hook it onto the picture hanger. Circuit board wiring section 3 1 5 3 1 6 3.

Wiring connections section 1 2 9 1 elite should or visa versa 2. Pull the safety lock lever on the end of the roller tube forward with the hook of an awning rod to place it in the. How to open an a e awning. Insure the arm top centered with the main support arm.

Pinch hazard. Push the travel lock on the side of the arm up. Awning does not close during high wind 1. If awning is over extended press horizontal distance of at least 16 between fully open awning and any permanent object.

For traveling roll up the awning as normal. Failure toggle down retract briefly on awning switch until valance is in correct position. You can use your hands to pull the strap the rest of the way until the awning is fully extended. Pull the support arm to release the ratchet attached to the other end of the lever.

Always measure from center bolt to center bolt for awnings. Use the rod to pull the strap straight out opening the awning. Wiring connections section 1 5 2. For awning orders it is important to measure the size correctly as awning orders are non cancelable non returnable and non refundable.

Switch section 4 1 3 2 7. Use our color chart to pick out the best choice of awning for your rv ing experience. Turn the adjustment lock knob on the back of the awning arm counterclockwise to loosen it. Maintain a verify valance is in correct position and adjust if necessary.

Release a sticky awning ratchet lever by releasing the awning lever with one hand while pulling down gently on the awning support arm with your other hand. Hook the black pull strap on the awning with your awning rod. Align pivot directly behind and bottom bracket. This technique works whether the awning is open or rolled up.

Roll out the awning using the awning rod.