Lay the first strip of material so that it overhangs the drip edges of your roof by about a quarter inch.
How to put a rolled roof on.
Go to your local hardware or building supplies store and ask for.
You can install roll roofing on your own but it goes more smoothly with a helper so grab a friend and get started.
You need to place starter strips of roll roofing along all edges of the roof so start by cutting pieces of roofing about 18 inches wide.
Attach drip edge along the edge of the roof with roofing cement.
Step 1preparing to install rolled roofing prepare the roofing cut the roll roofing into lengths long enough to cover one run across the shed roof or of 18 whichever fits your shed better and lay them out on a flat surface to smooth them out.
This reduces the chances of wrinkles after the roofing is installed.
Roofing contractor maintenance professional expert interview.
How to do it attach first course.
Purchase the appropriate amount of rolled roofing.
For laying the material in the corners internal and external it must be cut as a larger sheet and then to be stuck overlapped.
Take proper safety precautions.
Attach the strip to the roof every 3 inches with nails pulling it tight as you go.
Bought this roll from home depot.
To lay the rolled material on the parapets cut a piece of the desired length then mechanically attach it to the top edge of the parapet then glued to the base fabric fusing.
This is not a how to video.
X expert source david bitan.
Preparing to add rolled roofing 1.
Prepare a valley between joined roofs by cutting a strip that is 18 inches wide and covers the entire length of the valley.
Step 3 apply the edge strips.
Be careful not to get any on your skin in this process.
Nail it in place with roofing nails that penetrate at least 3 4 inch into.
Plan so that no two butt joints are closer than 2 feet from each other.
Overlap the next strip of roofing material with the first by at least 4 inches.
To seal a plumbing vent spread roofing.
Do not use the eaves as a guide instead because they can be uneven.
Don t put nails any closer to the edge of the roof than 1 inch.
Then apply roofing cement evenly around the roof edges where these strips are going to go.
Install roll roofing measure 35 inches up from the eaves at several intervals along the roof and mark them.
