How To Put Steel Siding On A Shed

The corner posts are the pieces of siding that will wrap around the corners of the surface you re working on.

How to put steel siding on a shed.

There should be an approximately inch gap between the corner and the siding strip on each side to allow for expansion. Fit the siding strip over the starter strip centering it between the corners. Drill a starting hole inside the panel and use a jigsaw to make the cuts. Set a circular saw to the depth of the siding and then cut along the line.

The exact installation process may vary depending on the siding you re using but generally you will need to position the posts on the corners and then nail them into place using the cut out nail slots. Install the corner posts that came with your metal siding first. To cut the siding to the roof slope on the shed you will use a straight edge to mark a cut line that matches the roof slope line. Have you wondered how to install steel siding on a pole barn.

Place the first siding sheet in place. Begin at the bottom corner of one side of the structure. Attach the sheets to the framing and secure them into place with 1 1 4 finishing nails. In this video i show how easy it can be.

Install the roofing screws vertically along each rib in the panel. Nail the sheet into place using the holes pre fabricated into the metal or nail the sheets to the studs according to manufacturer instructions. As you install the sheet metal siding be sure that the panels are lined up straight. Use a razor blade to cut the wrap and nail into place with a hammer using the 1 plastic cap nails.

Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof line. Measure the distance of the shed wall between corners and cut a strip of vinyl siding inch shorter. This is a plastic that helps to keep water out. Installing siding on e wall.

The sheets cover 3 foot so it goes up pretty fast. Use the same techniques to attach the siding around the other frame of the workshop. Be sure the larger edge is laid so that the small edge of the next panel will overlap it.