Next up is.
How to remove blazer roof rack 98.
Comes with 2 crossbars and 4 endcaps.
Shop chevrolet s10 blazer roof rack.
But if you choose to leave the driveshaft installed be sure the vehicle is at ride height before taking any measurements.
Using a t15 torx bit remove the screws that hold the rear supports to the side rails.
Pulled the roof rack off the lo hoe and added color matched mirror caps.
Slide each side rail forward approximately 6 10 mm to release them from the center supports.
For the most accurate results it s best to remove the driveshaft from the vehicle.
The length of a driveshaft.
Remove the rack assembly and place it upside down on a work table protected with clean shop rags.
Not really a lot needed to do this.
Cleaned the top and paint corrected.