Removing the siding for the ledger board.
How to remove siding for ledger board.
Avoid using galvanized flashing with acq treated lumber because it can cause corrosion.
Make the outline large enough to allow space for the.
Tips on removing vinyl siding for attaching ledger board wish i had a deck to build but some asshat with no license and insurance has been out there sucking them all up.
Actually too cold out there to be deck building.
Aluminum and vinyl siding can easily be removed with tin snips from an area one foot surrounding the ledger board location.
Learn how to cut and remove aluminum vinyl wood and cement board siding for installing a deck ledger board to a house wall.
If you need two or more pieces of flashing overlap the joints by 4 in.
Use a mallet or hammer to gently drive the tip of the bar up behind the siding if necessary.
And seal with silicone caulk.
Learn how to install deck ledger board spacers to allow air to flow behind your ledger board to prevent rot.
Installing deck ledger on vinyl siding duration.
You can then trim the pieces to be reinstalled with a j channel after the deck is completed for a clean finished look.
Step 2 pry the piece of siding out toward you gently to let you see the nail or screw patterning of how the planks have been fastened to the under structure.
Learn the tools techniques materials and fasteners to properly install a deck ledger board arguably a deck s single most important connec.
If necessary remove a few pieces of siding nail the undersill then replace the siding.
Tim copeland 73 700 views.
The next video is starting stop.
Tips on removing vinyl siding for attaching ledger board absolutely past the sill not much point in putting any housewrap on if you don t do that i like it the best when the foundation is 2 past on the right and 2 in on the left that makes siding much more interesting.
Nail j channel along both sides of the cutout.
Locate the rim joist and mark an outline on the siding where you want to position the ledger board using a tape measure pencil and chalk line.
Then tack the ledger into place with 16d nails.
Tack z flashing over the channel extending it slightly past the cutout on both sides.
