Fasten that shingle with two galvanized.
How to remove siding install flashing.
A the flashing was not properly installed.
How to install step flashing under siding.
Avoid using galvanized flashing with acq treated lumber because it can cause corrosion.
If the shingle already has flashing on it the kickout flashing has to slip beneath it and you ll have to loosen or remove siding to do this.
Attach the flashing tape above the window and then slip the drip cap into the siding and attach to the tape.
Step flashings are quite often improperly installed on the exterior of siding.
However in most instances step flashing should be installed behind siding.
The type and location of the flashings will vary depending on the type of windows and doors.
Failing to install step flashing behind siding.
Use roofing nails to install the l shaped flashing flush with the roof and wall then cover it with roofing cement and reattach the roofer s felt.
Lay a shingle over the step flashing starting at the roof edge.
Nail j channel along both sides of the cutout.
If you have vinyl or metal flanged windows for instance you can install drip cap flashing 4 the home depot over the window itself or over the top trim piece that you install.
Next slide drip flashing behind the vinyl so the lip fits over the top of the ledger as shown at right.
Install undersill trim along the edge of the vinyl over the flashing at the top and bottom.
Install the kickout flashing underneath the first shingle photo 1.
Then nail the new l shaped flashing under the builder s felt but above the fascia board.
In certain instances flashing may need to be installed on the exterior of siding.
Begin by removing the shingles at the affected area and removing old flashing if present.
Then tack the ledger into place with 16d nails.
Use a zip tool to disconnect two pieces of siding.
Using a pry bar you will need to remove a layer of siding from above the window you want to install the drip cap on.
Use an old rag to remove any dirt or debris that may be there.
Zip tools disconnect a higher piece from a lower piece.
Reveal the nails anchoring a piece to the wall by sticking the zip tool under the bottom of the piece above it.
For a wood window unit drip cap flashing can be installed over the trim piece often called brick molding that comes.
To remove a piece at your eye level slide the zip tool under the piece above that one.
Add felt if needed before nailing the new wood on and prime the new wood on all four sides before installing it.
It should go under the bottom two rows of siding then fold it out over the roof for at least 8 to 10 inches.
Fold the roof side of the.
