How To Replace A Hole In The Roof

Wear safety goggles and rubber sole work shoes.

How to replace a hole in the roof.

Replace any cracked rotted or missing siding making sure the new piece overlaps the step flashing by at least 2 in. Dig around with a putty knife to see if the area is sealed. In order to replace damaged roof shingles you need to remove the damaged shingle install the new one and seal the edges. Recaulk the corner flashing if any areas have hardened caulk.

Eight foot 1 2 inch thick plywood is standard sheathing material. Replace underlayment and shingles once you repair the hole in the roof plywood you need to seal up the seams and recover the roof. The first step in the repair of any metal roofing material will involve cleaning the surface. Cover the seams between the old and new decking with bitumen tape.

How to fix a hole in the roof step 1. Measure the opening of the section of roof to be shingled cut the plywood to size and nail to roof rafters. Dig out any suspect caulk and replace it with a high quality caulk. Replace any missing or rotted siding above the step flashing on dormers.

After cleaning the debris and reframing the roof lay down a base sheathing. Measure the repair area and cut a patch. Lay felt paper onto the roof overlapping the existing paper to get good coverage. Use an extension ladder with the third rung against the eave to.

Use the claw of a hammer to loosen the adhesive under the tabs 2 rows above the damaged shingles and then loosen any exposed nails with the claw. Also check the siding above the step flashing. Dig out any cracked or dry caulking that isn t properly sealing adjoining surfaces and replace with silicone caulk. A hole in a metal roof system.

Take up the shingles over the hole.