How To Replace Electric Awning Motor

With the solera power awning replacement motor your awning will be operating as usual in no time.

How to replace electric awning motor.

Be sure to apply tape before sliding the awning off the rv. Aecojoy 10 8 patio awning retractable sun shade awning cover outdoor patio canopy sunsetter deck awnings with manual crank handle beige. Remove the awning from the mounting bracket and lay it safely on the ground. You may have to rotate the motor slightly to get the gears to line up and then rotate it back in place to line up the bolt holes.

Connect the chain for the awning and plug into the electrical supply. Get to the motor using a ladder and open it up. Loosen the roller end bracket securing bolts and remove the bracket from the torsion bar by sliding it to the left end of the bar. Remove the bad motor and replace it with the new one.

Unbolt the chain from the drive shaft of the awning motor. Loosen the bolts holding it in place and lift it out of the housing. If your awning is really old use a sharp edge to cut away the sealant that connects the fabric to the track. You will need pop rivets reinstall the end cap.

Best seller in patio awnings. Install a new motor and tighten the bolts. Pull out the motor unplug the wire plug in the new motor and reverse everything. Unscrew the panel box and access the point where it makes the connection.

Replace electric awning fabric. Cover the upper awning brackets with electrical tape or masking tape. 4 6 out of 5 stars 34. After your awning is safely on the ground remove the end cap.

You have to connect back the wiring connection at the awing wiring and coach wiring before you do this step otherwise you wont have the voltage. Remove the connection and test the voltage at that point. The dual connector three bolt system was engineered with minimal components for fast user friendly installation saving you time and money from taking your rv or camper into the shop. Carefree r001326wht white rv travel r electric awning replacement motor.

Free shipping by amazon. This will make sure they don t scratch the side of the rv. Solera awning motor wires remove the 3 bolts that hold the motor in place using a 10mm wrench or socket. Drill out the rivets holding the end of the cap on the end of the roller.