How To Replace Piece Of Siding

Remove any nails from the top piece of good siding.

How to replace piece of siding.

Be sure to nail into the existing holes on the adjacent siding. Place the replacement piece of siding in the proper location pushing up until the lower lip locks with the piece below. Carefully slide the flat pry bar behind the damaged siding in order to pry out the nails. Replace siding by working from the bottom up you might need a helper here.

Ask this old house general contractor tom silva helps a homeowner repair sections of his vinyl siding that have holes. Face nail the top piece of fiber cement siding through the old siding. Locate the first piece of vertical siding that you re removing. Using the same process in step one unzip the piece of siding above the damaged piece and hold it out of the way.

It ll better match the house than brand new siding. Take the replacement board fit it in place image 2 and nail it in with a hammer using galvanized nails. Cut the fiber cement siding to length wear approved dust protection. Above the bottom edge.

Use a pair of tin snips or a utility knife to cut the siding and place a straightedge on the piece to keep your cut. Fill in the nail holes. Use framing square and utility knife to cut through face of siding. Space them about every 16 inches near the old nail holes.

Attach the siding with 10d galvanized box nails driven into the overlap at least 1 2 in. Install new siding slide the replacement piece up into place pushing up until the lower lip locks into the piece below it. Nail straight down on the replacement board in order to hit studs. To remove and replace damaged siding.

Roofing nails through the nailing flange. Blind nail the fiber cement siding in place starting with the bottom piece. Cut piece of faded siding from an inconspicuous spot to replace the damaged section. Subscribe to this old house.

The courses should overlap by at least 1 in. Pull siding away from house and cut through the bottom edge with aviation snips. When you replace the boards use a homemade reveal set jig to match the reveal of the existing siding.