How To Start 3 4 Tongue And Gtove Siding

1 you re usually working over your head.

How to start 3 4 tongue and gtove siding.

The stales are installed every 12 into the tongue of the board and are covered and hidden by the next boards groove is installed. Insert the nails into the tongue at an angle and use enough force to have the nail flush with the surface of the tongue. Secure the first row by nailing into the tongue to the joist or furring strip and secure the groove side of the plank by face nailing into the joist. In horizontal application start at the bottom and work up with the grove edges facing downwards to assure a weather tight wall.

This is called blind nailing the only location that we installed fasteners in the face of the. Wider siding should be face nailed using two nails per piece. Siding up to 6 inches wide can be blind nailed with one siding nail per bearing toe nailed through the base of each tongue. Nails must penetrate 1 1 4 inches into solid wood.

To install tongue and groove paneling vertically begin by nailing 1 by 3 furring strips horizontally either directly to the wall studs on a new wall or over the drywall on a finished wall. 3 tongue and groove isn t always flat so you have to force the boards together to get them seated. Carefully slice the back part of the groove of your replacement board but leave the front part of the groove attached. The paneling will be nailed directly to these furring strips.

Siding up to 6 in. Tongue and groove siding can be installed horizontally or vertically. How to install tongue and groove siding. Insert your new board s tongue into your old board s groove and lay the new board s front groove over the other old board s tongue.

When installing being by nailing one board to the top of the wall. How to install vertical tongue and grove siding. 2 you have to seat the tongues and grooves together and they don t always want to marry. Nail up the first panel at a corner of the room with the tongue side facing out.

Wide can be blind nailed with one casing nail per bearing toe nailed through the base of each tongue. With tongue and groove planks each piece has a side where there is a groove cut along the length of the board and a side where a tongue runs the length of the board. Sheathing should be a minimum of 5 8 inch thick and 3 4 inch thick is even. Installing tongue and groove walls can be a real workout.

The fun with this kind of millwork is in the name. We used 1 1 4 long 1 4 galvanized staples to install this cedar. In horizontal application start at the bottom and work up with the groove edges facing downwards. You can use your circular saw set to the depth of just the back part of the groove.