Wrap your tarp around the board then secure the board to the roof with a screw.
How to tarp a roof without nails.
Most tarps have grommets that will allow you to tie off the tarp to your roof.
How can can i use a tarp on a metal roof without the the nail put a hole in my shingles.
Installing tarp on a roof without nails.
Installing a tarp on your roof is easier than you think.
Never lay the tarp out during a storm.
Time wind and rain will eventually pull those nails right through the tarp if you don t use wood and you ll have a flapping tarp on your roof doing nobody any good.
You may need to put nails in or around your soffit area to tie off the ropes and tarp.
Don t simply nail into the tarp.
Continue along the length of the ridge line.
Next install furring strips to the parallel bottom side of the tarp.
Once you re on the roof and ready to rock and roll spread out your tarp to the coverage you want.
Make sure to tighten the tarp as much as possible to the structure.
The board must be 2 feet longer than the tarp s width and it should sit against the roof to avoid the collection of rainwater snow or debris.
Place the plywood or sheet metal over the hole and use roofing nails and a hammer or decking screws and a cordless drill to secure the plywood to the roof.
If your tarp is too.
You need to know first which spot on the roof needs tarping up.
Place the 2 4 against the roof along the rake to prevent water collection.
Roll the tarp over the damaged area taking care that it extends at least 3 on all sides.
Lay the tarp across the roof so that at least 4 feet 1 2 m lies on the sloped part of your roof on each side known as the peak.
The 2 by 4 should be about 2 feet longer than the tarp width.
Screw the 2 by 4 directly into the roof to secure it.
Starting at a corner drive a galvanized roofing nail into the strip and into the roof sheathing.
Using nails attach the peak end of your tarp to a 2 4.
Let the rest of the tarp hang off the lower border of the roof that overhangs the wall known as the eave.
Thomas boni july 8 2018 at 3 29 pm.
These nails should be placed 12 to 18 apart.
Then fold the excess tarp under a few rotations for a tight clean fit.
It s even easier if you do it without nails.
Find the source of the leak.
Your 2 4 should be two feet longer than the width of your tarp.
Extend the top edge of the tarp over the roof.
Pull the tarp tight and smooth out wrinkles.
Here are the steps on how to install a tarp on your roof without nails.
Lay the tarp out flat over the roof.
