How to install roofing tar paper step 1.
How to install roofing paper on a roof.
Staple this felt down starting at the lowest point of your roof and working upward.
Lay the first strip of tar paper side to side with its bottom.
How to install roofing paper.
Use plenty of staples and work carefully to avoid tearing the paper.
Use a chalkline or align it by eye to make sure it is straight then drive roofing nails every foot or so to fasten it to the sheathing.
Step 1 prep the area.
Roof felt also known as tar paper is a waterproof fiberglass product.
Begin your first row of tar paper with the bottom of the tar paper.
Measure your roof s surface in square feet and purchase enough tar paper to cover the entire surface twice.
Before securing the end of a row take time to walk the row smoothing out any rough spots and matching up the snapped chalk lines.
It can help prevent the picture framing effect or the pattern of your wood decking telegraphing through your shingles by providing an extra layer on top of uneven wood.
Measure the size of your roof in square feet.
Use a ladder to reach the bottom level of the roof.
Smooth application of the roofing paper will help you achieve a smooth installation of the shingles.
Roofing felt also known as tar paper serves as both an extra layer of protection between the shingles and the plywood and as a temporary moisture barrier until all the shingles are in place.
Step 3 overhang paper.
Whatever your reason for attaching.
Lay the next strip.
Paper can be fitted around vent pipes by cutting a slit and then putting it over the pipe.
Measure the width and height of each section separately.
This video contains the.
An assumption is made all materials are ordered based on the necessary measured requirements.
Some roofers will use 15 pound 6 8 kg roofing paper which is an effective method although the best method is a self sealing membrane with a rain screen.
Step 5 secure ends.
Step 2 roll it out.
It is used for temporary roofing for weatherproofing and as an underlayment under shingles or other permanent roofing materials.
Step 4 over the peak.
Overlap each row at least 3 inches.
Multiply the width by the height for the.
Cut drip edge flashing at an angle at the corner press it lightly against the eave end not too hard or you will misshape it and drive a nail near the end.
Apply drip edge to the eave.
Clean the decking as well as.
