To seal a plumbing vent spread roofing.
How to install rolled roofing on a patio.
Tack the upper edge of the second strip.
Use a trowel to scoop up the roofing cement.
3 take a roll of 18 inch wide roofing and use it to cover the length of the valley.
Snap a chalk line as a guide for the first layer roofing.
Snap a chalk line on the top of the first piece 2 inches below the edge.
Apply roofing cement to the roof.
Do not use the eaves as a guide instead because they can be uneven.
Using the exposed nail method snap a chalk line 35 inches above the eave.
How to do it attach first course.
Install the rest of the.
Installing the rolled roofing 1.
Using a measuring tape measure 35 inches 89 cm up from.
Install roll roofing measure 35 inches up from the eaves at several intervals along the roof and mark them.
Position the first sheet tack the top every 2 feet and nail the rake and.
2 like any other roof project you should start this one by addressing the valleys.
Plan so that no two butt joints are closer than 2 feet from each other.
Cut the rolled roofing.
Mark a chalk line to identify the end of your first layer.